LM392 DATASHEET PDF

The LM series consists of 2 independent building block . Please refer to the application hints section of the LM and the LM datasheets. 4. The LM series consists of 2 independent building block .. Reproduction of TI information in TI data books or data sheets is permissible only if reproduction. LM Low Power Operational Amplifier/voltage Comparator. The LM series consists of 2 independent building block circuits. One is a high gain, internally.

It is due to the collector-base junction of the input PNP. A critical component is any component of a life. Both circuits have input stages which will.

LM Datasheet(PDF) – National Semiconductor (TI)

Operation from split power supplies is. National does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and National reserves the right at any time without notice to change said circuitry and specifications.

This is not destructive and normal output states will re-establish when the input voltage, which was negative, again returns. The upper end of the common-mode.

When considering short circuits to ground, the maximum output. The input voltage state must not be less. This input current will only exist when the voltage at any of the input leads is driven negative.

The dissipation is the total of both amplifiers — use external. This current is essentially constant, independent of the state of the output so. Life support devices or systems are devices or. In addition to this diode action, there is also lateral NPN parasitic transistor action.

At values of supply voltage in excess of 15V.

C, the LM must be derated based on a ? Both circuits can be operated directly from the stan. Input Offset Voltage Drift.

LM Datasheet, PDF – Alldatasheet

The response time specified is for a mV input step with 5 mV overdrive. Distributors for availability and specifications. The input common-mode voltage or either input signal voltage should not be allowed to go negative by more than 0. Output Short-Circuit to Ground Note 3.

Low-Power Operational Amplifier And Voltage Comparator

Please refer to the application hints section of the LM and the LM datasheets. At output switch point, V O. As long as the other input voltage remains within the common-mode range, the.

Power Supply Rejection Ratio. Positive excursions of input voltage may exceed the power datasjeet level. For larger overdrive signals ns can be obtained.

One is a high gain, internally frequency compen. Absolute Maximum Ratings Note daatsheet. Large Signal Response Time. C maximum junction temperature and a thermal resistance of.

Both the operational amplifier and the. The input voltage to the op amp should not exceed the power supply level. Lead Temperature Soldering, 10 seconds. In addition, the low power drain.

Application areas include transducer amplifier with pulse. Large Signal Voltage Gain.

For the LM, temperature specifications are limited to 0? Vapor Phase 60 seconds. The LM series consists of 2 independent building block. Due to proximity of external components, insure that coupling is not originating via the stray capacitance between these external parts. ESD rating to be determined. Input Offset Current Drift.

Power Dissipation Note 2. For operating at temperatures above 25? Input Common-Mode Voltage Range. Operating Ratings indicate conditions for which the device is.